HBK FIT-AED-Kit, Operating Manual

Page: 12 / 48

FIT
®
-AED-Kit
SETUP FOR INITIAL COMMISSIONING
10
6.1 AED9401A
You can omit connections you do not need, depending on whether you want to connect
to the AED via the CAN bus or the diagnostics bus. Connect only the connections you
want on the Starter Kit to those on the AED according to the following schematic:
Connection labeling on the Starter Kit Connection labeling on the AED
U
B
(KL3, KL5 or KL7) U
V
(KL1 or KL2)
GND (KL3, KL5 or KL7) GND (KL1 or KL2)
IN1 … 2 (KL6 or KL8) IN1 … 2; also interconnect the two GND
connections of KL1 above
OUT1 … 4 (KL6 or KL8) OUT1 … 4 (KL2)
CanH in (KL4) CAN H (KL3 or KL6)
CanL in (KL4) CAN L (KL3 or KL6)
RA/TA (KL4) RA/TA (KL5)
RB/TB (KL4) RB/TB (KL5)
You can switch the inputs to high level by operating the relevant switches IN1 and IN2.
The LEDs OUT1 to OUT4 indicate the level of the corresponding outputs.