16
During operation do not reach into extractor device!
Lubricate the threaded spindle 4930-1 before each use!
2
For Your Safety
caused by improper use of the tool set will
be void.
• Any personal injury or material losses caused
by improper use are the sole responsibility
of the owner.
• Prior to each use lubricate the threaded
spindle 4930-1.
• During operation of the threaded spindle
do
not
reach into the extractor device oth-
erwise there is a risk of severe injury!
• Classifiction to vehicles:
Vehicles with wheel bearing
x
85 mm
VW Touareg
with 16 inch chassis
VW T 5
Vehicles with wheel bearing
x
72 mm
auDI a1
since 2011
auDI a2
since 2000
SKoDa FaBIa
since 2000
VW PoLo
since 2002
VW FoX
since 2005
SeaT IBIza
since 2002
Vehicles with wheel bearing
x
66 mm
VW PoLo
SKoDa FaBIa
Vehicles with wheel bearing
x
62 mm
VW LuPo
auDI a2 1.2 L
1. Owner’s Liability
This tool set was developed and man-
ufactured according to the technical
norms and standards valid at the time
and is considered to be operationally reliable.
Nevertheless, the tool set can present a dan-
ger when it is not used as intended or in an
inappropriate way by non-qualified personnel.
Please make sure that any person using this
tool set or carrying out maintenance work
reads these operating instructions carefully
and understands fully all information given,
before using the tool.
• Keep the operating instructions together
with the tool set at all times.
• Any modification of the tool set is strictly
forbidden.
• All security advices, warning and operation
notices on the tool set have to be kept leg-
ible. Replace all damaged labels or stickers.
• All indications concerning setting values
and setting ranges must be observed.
2. Appropriate use
Operational reliability can only be
ensured, if the tool is used as intend-
ed and in compliance with the indica-
tions given in the operating instructions. In
addition to the safety advice given in these
operating instructions, the general safety regu-
lations, regulations for the prevention of acci-
dents and for environmental protection being
valid for the application area of the tool set
have to be observed and respected.
Always ensure tools are used, inspected and
maintained in compliance with the respective
local, state, national or federal regulations.
• The tool set must only be used if it is in good
conditions.
• All safety equipment must always be within
reach and should be checked regularly.
• The tool set is intended for dismounting/
assembling wheel hub bearings on passen-
ger cars. See
list
at the end of this page.
• The tool set is only intended for manual use.
• Any deviation from the intended use and/
or any misapplication of the tool set is not
allowed and will be considered as improper
use.
• Any claims against the manufacturer and/
or its authorized agents because of damage
Summary of Contents for HAZET 4934-2562/6
Page 27: ... 27 Notizen Notes ...
