HAZET-WERK
Hermann Zerver GmbH & Co. KG
;
Güldenwerther Bahnhofstraße 25 - 29
•
42857 Remscheid
•
GERMANY
[
+49 (0) 21 91 / 7 92-0
•
\
+49 (0) 21 91 / 7 92-375
•
^
hazet.de
•
]
35
Electrical energy may cause serious injuries!
Always wear personal protective equipment!
3
Design and function
Installing and removing the wheel
Depressed centre wheel must be used with the
included flanges.
• Turn off the tool and remove the battery pack.
• lnstall the unthreaded backing flange on the spindle
with the raised section (pilot) against the wheel.
• Place the wheel against the backing flange, centring the
wheel on the raised section (pilot) of the backing flange.
• While pressing the spindle lock button, thread the
threaded clamp nut on the spindle.
lf the wheel you are installing is more than 1/8" (3 mm)
thick, place the threaded clamp nut on the spindle so that
the raised section (pilot) fits into the centre of the wheel.
lf the wheel you are installing is 1/8" (3 mm) thick or less,
place the threaded clamp nut on the spindle so that the
raised section (pilot) is not against the wheel.
• While pressing the spindle lock button, tighten the
threaded clamp nut with the included wrench.
• To remove the wheel, press the spindle lock button
and loosen the threaded clamp nut with the included
wrench.
Backing flange
1/4" (6 mm) wheel
Threaded clamp nut
Backing flange
1/8" (3 mm) wheel
Threaded clamp nut
Note:
lf the wheel spins after the threaded clamp nut is tightened, check the orientation of the
threaded clamp nut. lf a thin wheel is installed with the pilot on the clamp nut against the
wheel, it will spin because the height of the pilot prevents the clamp nut from holding the
wheel.
Caution!
Do not tighten the adjusting screw with the latch in the open position. Undetectable
damage to the guard or the mounting hub may result.
Warning!
Do not engage the spindle lock while the tool is operating. Damage to the tool will result
and the attached accessory may spin off, possibly resulting in injury.
Warning!
Always take off and remove the battery before changing the accessories. Failure to do this
could result in serious personal injury.
Only use accessories with a safe operating speed higher than rated speed of the tool.
