27
HAZET-WERK
Hermann Zerver GmbH & Co. KG
;
Güldenwerther Bahnhofstraße 25 - 29
•
42857 Remscheid
•
GERMANY
[
+49 (0) 21 91 / 7 92-0
•
\
+49 (0) 21 91 / 7 92-375
•
^
hazet.de
•
]
Electrical energy may cause serious injuries!
Always wear personal protective equipment!
Note:
High operating noise level!
Always wear hearing protection!
Tightening and loosening screws:
• A suitable socket based on the screw size must be selected and fitted
for tightening and loosening a screw.
• Caution: the screw can be tightened too much and break if the screw
is tightened for too long!
• Always tighten the screw with the impact wrench at a right angle
to the screw.
• A slanted impact wrench may damage the screw head
and will not transmit the force to the screw.
Before charging:
• Check the power source voltage against the permissible voltage on the charger's name
badge.
• Loading voltages higher than allowed represents a fire hazard to the charger.
• Check the cables for damage. Replace any damaged cables prior to use.
• Connect the charger to the power source. All 3 charging LEDs light up for 1 - 2 seconds.
• Slide the battery headfirst with the terminal side into the charger. Make sure that the
battery fits in the charger slide and that the contacts snap into position.
• If the charger detects an overheated battery, all 3 charging LEDs flash at the same time.
Remove the battery and let the charger cool for about 15 - 30 minutes before you con-
tinue charging.
3
Design and function
