HAZET-WERK 9035/6, Operating Instructions Manual

Page: 10 / 24

10
Technical data are subject to change without notice
Do not leave plugged-in pneumatic tools unattended.
Always wear personal protective clothing and safety equipment.
For Your Safety
(max. air pressure see table, page 8).
Exceeding the approved maximum pressure
of tools and accessories can cause explo-
sions and may result in severe injuries.
• Check tight fit of the air hose connec-
tions / do not use defective pressure
hoses.
Uncontrollably moving pressure
hoses may cause severe injuries.
• Only disconnect pneumatic tools in an
unpressurized state.
Uncontrollably moving
pressure hoses may cause severe injuries.
• Use clean and dry air only. Never use oxy-
gen, carbon dioxid or other bottled gases to
power pneumatic tools.
• Only use parts, attachments and acces-
sories that are recommended by the
manufacturer.
• Never carry the tool by the compressed
air hose.
• Do not carry the plugged-in tool with a fin-
ger on the operation trigger.
• Avoid unintentional starting.
• Handles should be clean, dry and free of
oil and grease.
• Always keep the work area clean, well
ventilated and well lit.
• Do not use the tool under the influence of
alcohol or drugs.
• The maintenance and operation of chisel
hammers are exclusively permitted to
persons who have been instructed accor-
dingly.
• Any repairs must be carried out by autho-
rized persons only.
• It is strictly forbidden to manipulate or
misuse the tool or to effect emergency
repairs.
• Never touch the chisel when the chisel
hammer is in operation.
• In the case of leakages or other malfunc-
tions, the appliance must be immediately
disconnected from the compressed air
supply and the cause of troubles has to be
eliminated.
GB USA