![background image](http://html.mh-extra.com/html/hazet-werk/9032-m-1/9032-m-1_operating-instructions-manual_2111504014.webp)
14
^
hazet.com
•
]
2
For your safety
• Keep children away from pneumatic
tools.
Unattended tools or tools that are con
nected to the compressed air supply may
be used by unauthorised persons and could
cause injury to them or to other persons.
• Do not use the device in explosive atmo-
sphere.
Tools such as sanders can cause
sparks that may ignite combustible mate
rials. Never operate tools in proximity to
combustible substances like petrol, naphtha
or detergents, etc. Work in wellcleaned and
wellventilated areas only. Keep combustible
materials out of the work area. Never use
oxygen, carbon dioxide or other bottled
gases to power pneumatic tools.
• Do not point the device at another per-
son.
Keep children and other persons out of
the work area when operating the tool.
• Do not operate the device in an idle state.
• Do not allow pneumatic tools to come
into contact with sources of electricity.
• Pay attention to the working pressure.
For max. air pressure see table on page 7.
Exceeding the approved maximum pressure
of tools and accessories may cause explo
sions and may result in severe injuries. The
maximum pressure of the compressed air
must be equal to or less than the approved
pressure load indicated for the sander.
• Check tight fit of the air hose connections.
Do not use defective pressure hoses.
Uncontrollably moving pressure hoses may
cause severe injuries.
• Only disconnect pneumatic tools when
they are not pressurised.
Uncontrollably
moving pressure hoses may cause severe
injuries.
• Use clean and dry air only.
Never use oxy
gen, carbon dioxide or other bottled gases
to power pneumatic tools.
• Only use spare parts, supports and
accessories which are recommended by
the manufacturer.
• Never carry the tool by the compressed
air hose.
• Never carry the connected tool with a
finger on the operating lever.
• Avoid unintentional actuation.
• Always keep the grips dry, clean and free
of grease or oil.
• Make sure that the working area is clean,
well ventilated and always well lit.
• Never use the tool whilst under the influ-
ence of alcohol or drugs.
• Repair work must only be carried out by
authorised persons.
• Labels on the tool must always be kept
legible. The user is responsible for ensu-
ring that the sticker stating warning signs,
rotation speed, the serial no. and the
article no. is not damaged and is easy
to read.
• Do not use quick-release couplings
directly on the tool. There must be a
pressure hose of at least 20 cm in length
between the tool and the quick-release
coupling.
• Only replace grinding wheels when the air
hose is disconnected.
• Always disconnect the tool from the com-
pressed air supply when replacing the
grinding wheels and observe the safety
instructions.
• Only use the grinding wheels intended for
use with the device.
Immer persönliche Schutzausrüstung tragen!
Always wear personal protective equipment!