USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
15
•
Low Flow – Generally:
1.
Clogged or restricted strainer or suction line. Clean skimmer strainer basket and/or pump strainer basket.
Contact a qualified repair professional.
2.
Undersized pool piping. Correct the piping size.
3.
Plugged or restricted discharge line of filter, valve partially closed (high gauge reading). Sand filters –
backwash as per manufacturer’s instructions; D.E. filters – backwash as per manufacturer’s instructions;
Cartridge filters – clean or replace the cartridge.
4.
Air leak in suction (bubbles issuing from return fittings). Re-tighten the suction and discharge connections
using Teflon tape. Inspect other plumbing connections, and tighten as required.
5.
Plugged, restricted, or damaged impeller. Replace the impeller including a new seal assembly.
•
Noisy Pump:
1.
Air leak in suction piping, cavitations caused by restricted or undersized suction line or leak at any joint, low
water level in pool, and unrestricted discharge return lines. Correct the suction condition or throttle return
lines, if practical. Holding your hand over the return fitting will sometimes prove this, or by putting in a
smaller eyeball fitting.
2.
Vibration due to improper mounting, etc. Mount the pump on a level surface and secure the pump to the
equipment pad.
3.
Foreign matter in the pump housing. Loose stones/debris hitting the impeller could be the cause. Clean the
pump housing.
4.
Motor bearings can become noisy from normal wear, rust, overheating or concentration of chemicals. If the
motor bearing seal is damaged from leaks, chlorinated water can seep into bearing washing out the grease
and could cause the motor bearing to whine. Replace the motor and any seal leaks should be repaired at
once by replacing the shaft seal.
5.
Place pump closer to water level.
10.
Warranty
1.1.1.
HAYWARD
®
Pool Products Limited Warranty
To original purchasers of this equipment, Hayward Pool Products, Inc. warrants its pumps to be free from defects in materials and workmanship for a
period of ONE (1) year from the date of purchase, when used in single family residential applications.
The limited warranty excludes damage from freezing, negligence, improper installation, improper use or care or any Acts of God. Parts that fail or
become defective during the warranty period shall be repaired or replaced, at our option, within 90 days of the receipt of defective product, barring
unforeseen delays, without charge.
Proof of purchase is required for warranty service. In the event proof of purchase is not available, the manufacturing date of the product will be the
sole determination of the purchase date.
To obtain warranty service, please contact the place of purchase or the nearest Hayward Authorized Service Center. For assistance on your nearest
Hayward Authorized Service Center please visit us at
www.hayward.com
.
Hayward shall not be responsible for cartage, removal, repair or installation labor or any other such costs incurred in obtaining warranty replacements
or repair.
The Hayward Pool products warranty does not apply to components manufactured by others. For such products, the warranty established by the
respective manufacturer will apply.
The express limited warranty above constitutes the entire warranty of Hayward Pool Products with respect to its’ pool products and is in lieu of all other
warranties expressed or implied, including warranties of merchantability or fitness for a particular purpose. In no event shall Hayward Pool products be
responsible for any consequential, special or incidental damages of any nature.
Some states do not allow a limitation on how long an implied warranty lasts, or the exclusion of incidental or consequential damages, so the above
limitation may not apply to you. This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state.
Hayward Pool Products
620 Division Street
*Supersedes all previous publications.
Elizabeth, NJ 07207
