4
With power removed to the pump and water drained from the pool plumbing,
secure the Cutting Template to the location where the Cell Vessel will be installed.
Note that the Cutting Template is the same width as the Cell Vessel. The entire
Cutting Template must fit on the pipe otherwise the Cell Vessel will not fit. With the
Cutting Template secure on the pipe, mark all 10 cutouts on to the pipe using a
waterproof permanent marker.
Remove the Template, cut the pipe and install the Nut Assemblies as shown below.
Use the included 2” Nut Assembly for 2” pipe and 1½” Nut Assembly for 1½” pipe.
Place Nut Assembly on each side of the cut pipe (threads face in). Be sure to place
the Nut, Compression Ring and Collar on the pipe as shown in the diagram.
FROM
POOL
TO
POOL
FILTER
PUMP
Cu
t
Pi
p
e
He
re
Cu
t
P
i
pe
Her
e
In
d
ic
atin
g
Ma
rks
In
dic
a
ti
ng
Mar
k
s
C U TTI N G T EM PLA T E
1. Se c ure ly hold this Cu t tin g T
em plate to the desired pipe. Th e ent ire le ngth of the Gu i de
mu s t fit in th e lo catio n wh ere the c e ll ves sel w ill be in s tall ed.
2. With a
perma n ent ma r ker, ma r k the cut, co m
pres sion rin g , and indic a tor m
ark cu tout
on to the pipe.
3. Re m o v e Cutting T
em plate and cut pipe at bot h lo cat io ns
.
4. Sli d e Nuts on to the pipe w
ith thre ads fac ing the cut ends.
5. Sli d e the Co m p ressio n Ri ngs ov er the mark in gs made on the pipe.
6. Sli d e the Sp ace rs betwe e n the cu t end and the Co m p ression R ings.
7. Inse rt the Ce ll Vesse l between the cut ends and sli d e the Nu ts to engage the threads on
the C ell V
es sel.
8 . H a n d ti ghte n a n d con t in ue to ti g hten N uts a n add it io na l 1 /4 turn w
it h th e in cluded St rap Wr e nch.
9. Th e back of the tight ened N
uts sh ould be lo cated on the In dicating Ma rks. If not, lo o sen Nu ts
and re- positio n the C e ll V essel. No t e: wh e n proper ly in stall ed, the cu t pipes do go full y
into the C
e ll V essel.
w
aterpr oof
NO T
Mark all
10 cutouts
Permanent
Marker
C
ut P
ip
e H
er
e
Cu
t P
ip
e He
re
Indi
ca
ting
M
ar
ks
Indi
ca
ting M
ar
ks
Cut Pipe and
Clean Shavings
Mark Pipe
Slide Nuts
on Pipe
Slide Compression
Rings on pipe
Slide Collars
on pipe
1
2
3
4
5
CUTTING TEMPLATE
Securely hold or tape this Cutting Template to the desired
Cell Vessel installation location. Use a waterproof permanent
marker to mark the pipe. When finished, there should be 12 marks
on the pipe. Follow procedures on the Installation Quick Start Guide
to complete Vessel installation.
