Hayward Powerline EcoPac 81502, Installation Instructions Manual

Page: 45 / 101

8
3.5 Initial start-up
Start-up procedure – once installed, perform the following steps:
1) Turn the fan by hand to check that it turns freely, and that the blades are
properly attached to the motor shaft.
2) Check that the unit is correctly connected to the main power supply (see
wiring diagram in the appendix).
3) Turn on the filtration pump.
4) Check that all the water valves are open, and that the water flows towards
the unit before switching on the heating mode.
5) Check that the condensate drainage hose is attached correctly and does
not cause an obstruction.
6) Turn on the unit’s power supply, then press the On/Off button on the
control panel.
3. INSTALLATION AND CONNECTION (continued)
Models 81502 81512 81522 81542
Electrical
connection V/Ph/
Hz
230 V

1/50 Hz
230 V

1/50 Hz
230 V

1/50 Hz
230 V

1/50 Hz
Fuse rating
aM
A 8 aM 10 aM 16 aM 20 aM
D-curve
circuit breaker
A 8 D 10 D 16 D 20 D
The electrical power supply must have a motor power supply (aM) or
D-curve circuit breaker fuse protection device, as appropriate, and a
30mA earth-leak circuit breaker (see table below).
Always turn off the mains power supply before opening the electrical
control box.