Wiring
Refer to the diagram below for the location of the wiring connectors for temperature sensors, valve
actuators and low voltage pool/spa equipment. For detailed information about wiring these compo-
nents, Low Voltage Wiring section of the OmniLogic Installation manual.
When making these connections, be aware that wires should be routed to the low voltage side of
the OmniLogic. Taking care when routing wires will help prevent the possibility of pinching a wire
when re-mounting the panel.
After all connections have been made, use wire anchors and ties to secure the bundle of wires coming
from the HLIOEXPAND. Two anchors (with adhesive back) and two nylon ties straps are provided.
When determining a location to mount the anchors, be sure to position wiring below the deadfront
and above the OmniLogic's main board.
Note that the actuator outputs are protected by a 4 amp "automotive" type fuse. This fuse can be
replaced if necessary.
Sensor
2
Sensor
4
Sensor
3
Sensor
1
LV
2
LV
4
LV
3
LV
1
Valve1
Valve2
Valve3 Valve4
4A replaceable fuse
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
4
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
4
