USE ONLY HAYWARD
GENUINE REPLACEMENT PARTS
Page 10 of 16
Commercial Filter Valve Adapter Kit
ISHCV375 Rev-A
4.
Standard PVC Socket Connection Gluing Practices
Solvent cementing of socket end connections to pipe should be performed per ASTM specifications
D2855-96.
4.1.
Cut the pipe square.
4.2.
Chamfer and deburr the pipe.
4.3.
Surfaces must be cleaned and free of dirt, moisture, oil and other foreign material.
4.4.
Apply primer to the PVC elbow inside socket surface. Never allow the primer or cement to
contact the union connector o-ring sealing surfaces, as leaking may result. Use a scrubbing
motion. Repeated applications may be necessary to soften the surface of the socket.
4.5.
Liberally apply primer to the male end of the pipe to the length of the socket depth.
4.6.
Again apply to the socket.
4.7.
Without delay, apply cement to the pipe while the surface is still wet with primer.
4.8.
Next apply cement lightly, but uniformly to the inside of the socket.
4.9.
Apply a second coat of cement to the pipe, and assemble the end connector to the pipe,
rotating the connection 1/4 turn in one direction as it is slipped to full depth on to the pipe.
4.10.
The connector should be held in position for approx. 30 seconds to allow the connection to
“set”.
4.11.
After assembly, wipe off excess cement.
4.12.
Full set time is a minimum of 30 minutes at 60° F to 100° F. Full cure time should be based on
the chart below.
