29
In addition to teaching the unit, it is recommended to conduct a range test to verify
the RF signal strength between the AquaConnect and the pool controller.
Power cycle the ACHN, then reteach it (
page 8
). IF the
Tx and Rx LEDs appear then go to step 1F. IF the LED
still do not appear then replace the AquaConnect
device (
AQ-CO-HOMENET
).
Identify the IP address assigned by the router to the
ACHN. Follow steps on
pages 13-17
for more
information. IF LAN control still does not work, then
proceed to step 1G.
Step 1E
Step 1F
Locate & Use the IP Address
Power Cycle the Unit & Reteach
NOTE: The IP address assigned to the AquaConnect is subject to change. Because the router is
assigning the IP address it may change due to the Dynamic network set up. Learning the process to
locating the IP address is beneficial if LAN control is desired.
1. LAN Function Not Working (cont.)
Summary of Contents for AquaConnect AQ-CO-HOMENET
Page 7: ...How To AquaConnect ...
Page 25: ...Troubleshooting Guide AquaConnect ...
