Hayman Reese 03229RW Installation Instructions Manual Download Page 2

Page: 2 / 14

HAYMAN REESE

PART No:

03229RW

TOYOTA CAMRY ASV70R CL4

INSTALLATION INSTRUCTIONS

PLEASE ENSURE THAT INSTRUCTIONS ARE UNDERSTOOD PRIOR TO FITMENT

PLACE THESE INSTRUCTIONS IN THE VEHICLE’S GLOVEBOX AFTER INSTALLATION IS COMPLETED

Rev: A

Page 2

Issue Date:

09-08-2018

Hayman Reese (Cequent)

PO Box 4050, Dandenong South VIC 3164

Phone 1800 812 017 Email [email protected]

FOR TOWING PURPOSES ONLY

For towing capacity details please refer to vehicle
own

er’s manual or to the manufacturer. Overloading can

void your warranties.

Warning:

1. Do not, drill, cut, weld or otherwise modify the towbar.
2. If you are using electric welding on a motor vehicle,

always

check that the vehicle is not equipped with electronic

engine or instrument management equipment. Failure to do so could

destroy

any on board computers. If in

doubt, check with the vehicle's manufacturer.

3. If TBM is used in inverted position tow ball may make contact with rear tailgate when lowered, which could cause

damage.

General:

1. Ensure all hardware items have been included refer to assembly diagram.
2. It is recommended that the instructions are read through and completely understood before making any

attempt to fit this product.

3. Be wary of any changes to vehicle designs or other accessories that may conflict with the installation of this

product.

4. Before drilling ensure that the area is clear of fuel, electrical & other components.
5. All holes drilled into the body panels shall have all burrs & swarf removed then coated with a suitable rust

preventative paint.

6. The high tensile fasteners supplied with this product were used to achieve the specified rating. If replacement

is required ensure that fasteners of the same rating & quality are used. Contact an authorised

Hayman Reese

dealer if further information is required.

7. Ensure that all hardware is fastened to torque list below check fasteners on regular basis.
8. Towbar load rating sticker provided with this product shall be conspicuously located on inside rear end of the

driver's door.

(See diagram below).

9. Hayman Reese recommends that you check your tow ball to ensure that it complies with the Australian

standards

AS 4177.2.

10.

PLEASE NOTE

: It is advised to remove your LUG or TBM when not actually towing so as to produce a clear

view of the vehicles registration plate if obscured, and to also provide maximum available departure angle.

Tow bar Maintenance and Care.

Hayman Reese recommends that bolt torque’s, as listed below, are routinely and regularly inspected and checked for
correct tension. Replace any worn or defective parts.
We recommended to remove Tow Ball Mounts (TBM’s, tongues or lugs) when not being used for any considerable
length of time.
So as to avoid injury, when not towing it is suggested that the tongue, Pull Pin and R-clip are removed then stored in a
safe, clean and dry place, away from excessive moisture.
Hitch Pull Pins and spring “R” clips are regularly checked for proper installation. Replace any worn or defective parts.