Haybuster H-1135, Operating Instructions Manual

Page: 42 / 176

32
H - 1 1 3 5 T U B G R I N D E R O P E R A T I N G I N S T R U C T I O N S
2.3.2 How to hook up to tractor
To hitch the H-1135 to a tractor, perform the following steps:
1. To reduce wear on the PTO shaft knuckle joints, tractor PTO shaft should be in line (parallel) with the
H-1135 Tub Grinder. If tractor is equipped with swinging drawbar, adjust so the tractor PTO and
H-1135 Tub grinder drive shaft are in line.
2. Connect hydraulic lines to the tractor.
3. Connect electrical lines to tractor.
CAUTION:
To insure a safe hook-up, the H-1135 Tub Grinder and tractor should be connected with
a 1” locking pin.
2.3.3 How to disconnect from tractor
To disconnect the H-1135 from a tractor, perform the following steps:
1. Park H-1135 Tub Grinder and tractor on a level spot.
2. Lower jack to ground, place blocks under jack if ground is soft.
3. Disconnect electrical wires.
4. Disconnect hydraulic lines.
5. Disconnect PTO, place shaft in shaft holder.
6. Raise hitch of H-1135 Tub Grinder to remove weight from tractor hitch by adjusting jack.
7. Remove hitch pin.
8. Drive tractor away slowly.