22
MAINTENANCE AND STORAGE
1. Maintenance
Before any maintenance work, the machine must be switched off and completely cooled.
Perform the maintenance work according to the instructions below and perform them regularly.
A clean, well-maintained machine increases its standard of living and efficiency. On the
contrary, a machine maintained can cause damage, accidents and render the tool inoperable in
the short term.
Any other maintenance, modification or repair work must be carried out by a qualified
professional.
Do not immerse the tool in water or any other liquid.
a. After each use
- Clean the engine block louvers with a blower.
- Check the chain brake if it is working properly.
- Clean the plastic parts before wiping with a damp cloth.
- Check the use of the chain guide
- Check the auto lubrication circuit if it is obstructed or not.
- Check sprocket condition
- Clean the cylinder fins with a compressor
b. Cleaning the air filter
Use a compressor to blow dust and chips.
To clean the filter foam: open the air filter, remove the foam.
Clean this foam with gasoline, wring out and dry. Replace
the foam in the air filter and reassemble as described in the
diagram.
After 10 uses, replace the foam with a new one.
c. Cleaning the oil inlet
Disassemble the chain guide and the chain hood and check
that the oil supply is clean. If dirty, remove dirt with a clean
compressor or cloth.
