20
Operators should:
- Never cut with the rebound area at the end of the chain saw
chain guide
- Never hold and cut sections or
- Never try to catch sections when they fall.
e. Release of a jammed saw
If the saw gets stuck during cutting, the operators should:
- Saw the saw and attach it securely to the cutting foot of the
shaft (ie trunk side) or has a separate chord from the tool
- Pull the saw of the cluster while the branch is lifted, if
necessary,
- If necessary, use a hand saw or a second chainsaw to
release the chain saw.
5. Cutting work
The tool should only be used to cut trees. Do not use it for
other applications.
Do not attempt to remove the chainsaw when it is stuck
during operation. Stop the machine and remove the wedge
blade with a wedge.
Stick your feet well, keep a good balance and do not climb on
the tree trunk.
Try not to work on a slope. However, if you have to work on a
slope, always stand higher than the tree trunk.
Before bending a branch or trunk in bending, observe the
direction of bending and finish the cut opposite the bending
side to prevent the chain guide from getting stuck in the cut.
a. Felling of trees
Examine the work area and estimate where the tree will fall.
Start the machine as described above. Start by making a
notch in the direction of fall chosen.
When the tree falls, shout or make a beep to alert people in
the vicinity. When the shaft falls, move away from the cutting
area.
b. Trunk on the ground
Cut half of the trunk, turn it over and finish the cut on the
other side.
