48
You should see your device listed under Mac Address. Each HWREN2
on the network will have a unique Mac Address. This number should
correspond to the numbers/letters listed on the bottom of your device.
Please select the unit that you wish to configure. Next to the Mac
Address, there will be an IP address that is assigned to that particular
HWREN2. Highlight the unit and click ‘Connect’. A web browser
will open and take you into the setup page of the device. (Refer to earlier
sections on this manual.)
If the device does not appear, you may have to reset the unit. Press and
hold the reset button for 15 seconds, power off/on. Then reconnect and
start from section 2-1.
Summary of Contents for Hi-Gain HWREN2
