ALARM MEMORY:
When the motorcycle is set into arming normal or silent mode, press the
button, if the
led flashes continuously then motorcycle was tampered. to turn off alarm memory turn
on ignition key.
MEMORY FUNCTIOn
during the alert state, if the alarm is detached from the cable harness, when restored it will
“remember” the state in which was, preventing in this way every attempt of tampering.
LEARNING TRANSMITTER CODES:
(We have already done this for you!!!)
this alarm system can support up to 4 remote controls. the included transmitter is pre
programmed into the systems memory at the factory. Follow the below steps to add or
delete a new transmitter.
1. in disarming mode, ignition oFF position. turn the ignition on/oFF 8 times, stopped
at on at the last time, indicator light will flash twice, indicating the bike enters into code
learning mode.
2. Press and hold a button on the first remote for 1 second, indicator light flash once. the
first remote is learned.
3. Press and hold a button on the second remote for 1 second, indicator light flash twice,
indicating the second remote learned.
4. Follow the above procedures, the times the indicator light flash indicate the sequence of
the remote learned.
5. altogether 4 remotes can be learned. if the 5th remote learned, it will automatically
replace the first one.
after all remotes are learned, turn ignition oFF, indicator light will flash twice, the alarm
exits code learning mode. Verify the correct operation of each remote control.
Warning: after entering into code-learning mode, the previous remote codes
will not be cleared. to clear the previous remote codes (in case remotes were lost), learn a
new remote for at least 4 times, it will automatically replace all other remotes.
7
21
CONNECTING THE ALARM WITH SPECIFIC T HARNESS
(OPTIONAL EXTRAS)