Hawk X Pro Series User Manual Download Page 7

REMOTE START

 Read Warning! Safety First

Press the    button twice within two seconds and hold, engine will start automatically, 

and used for non-key driving and warm-up. Repeat the above operation if the engine does 

not function due to cold weather or due to slow rotation of engine.  

NOTE: when using the remote start up, the switch key of the motorcycle cannot be 

pressed at the same time, otherwise the fuse will blow.
How to turn off the remote start function: press the  
Disable Remote Engine Start (default on)

Long press        button, indicator lights flash 2 times. To enable remote engine start follow 

above procedure, indicator lights flash 2 times, siren sounds 2 times.  

 

button

 

once then engine will stop.

Warning! S

afety first

When properly installed, this system can start the bike via a command signal from the 

remote control transmitter.
Therefore, never operate the system in an enclosed area or partially enclosed area without 

ventilation (such as a garage).  It is the user’s sole responsibility to properly handle and 

keep out of reach from children all remote control transmitters to assure that the system 

does not unintentionally remote start the bike. THE USER MUST INSTALL A  CARBON 

MONOXIDE DETECTOR IN OR ABOUT THE LIVING AREA ADJACENT TO THE 

VEHICLE. ALL DOORS LEADING FROM ADJACENT LIVING AREAS TO THE 

ENCLOSED OR PARTIALLY ENCLOSED VEHICLE STORAGE AREA MUST AT 

ALL TIMES REMAIN CLOSED. These precautions are the sole responsibility of the user. 
Use of this product in a manner contrary to its intended mode of operation may result in 

property damage, personal injury, or death. (1) Never remotely start the bike with the bike 

in gear, and (2) Never remotely start the bike with the keys in the ignition. The user must 

also have the neutral Safety feature of the bike periodically checked, wherein the bike 

must not remotely start while the bike is in gear.  If the bike starts in gear, cease remote 

start operation immediately and consult with the authorized dealer to fix the problem.

OPERATION OF THE REMOTE START MODULE IF THE VEHICLE STARTS IN 

GEAR IS CONTRARY TO ITS INTENDED MODE OF OPERATION. OPERATING 

THE REMOTE START SYSTEM UNDER THESE CONDITIONS MAY RESULT 

IN PROPERTY DAMAGE OR PERSONAL INJURY. YOU MUST IMMEDIATELY 

CEASE THE USE OF THE UNIT AND SEEK THE ASSISTANCE OF AN 

AUTHORIZED DEALER TO REPAIR OR DISCONNECT THE INSTALLED REMOTE 

START MODULE. HAWK CAR ALARM WILL NOT BE HELD RESPONSIBLE OR 

PAY FOR INSTALLATION OR REINSTALLATION COSTS.

5

21

CONNECTING THE ALARM WITH SPECIFIC T HARNESS

(OPTIONAL EXTRAS)

Summary of Contents for X Pro Series













Reviews: