21
Note
When equip and remove 3.5” monitor, be careful to prevent the fall, fall damaged!
a.
Connecting LCD Screen to Video Endoscope:
Aim at red dot of LCD Screen and Video Endoscope, connect them, then screw down lock nut and fix
LCD Screen.
And use the cable to connect Monitor 8
”
with videoscope
b. Inserting SD Card:
SD cards face up, inserting SD card into the card slot. After turning on the LCD,
When remove the SD card, you can push the SD card, SD card will be popped up, then unplug it.
Warning
●
It cannot be used with HF hand instruments.
●
It cannot be used with laser device.
Do not disconnect all joint in the working condition, otherwise it will damage the device!
NOTE
SD Card must be inserted before turn on the power on, otherwise, no picture or video can be
taken.
SD card cannot be unplugged when it is in the working condition of videoscope, otherwise the
memory files will be damaged, or even damage the SD card.
When SD card is inserted into SD card slot,
will show on LCD screen.
The amount of photos and videos is based on SD card capacity and the time of the video can be
set in the menu. If “ Disk Full” shows on the screen when taking picture and capturing video, it
means disk is full, files cannot be saved anymore.
The current photo and video file will not be saved, in case the power is off.
4.1.4 If color is not satisfied, please aim the videoscope to the standard color, then adjust parameters of
monitor. Usually color has been adjusted to the best condition before out of factory, white balance
adjustment is not recommended and do not saving the white balance results. White balance: aim the
videoscope at white object at 1 ~ 2CM distance, press and hold the button, observed when the screen
