8
AFTER USE
WARNING!
To reduce the risk of electric shock or injury, unplug the power cord before
servicing.
1. Toggle the Power Switch to the MIDDLE position to turn off both the vacuum motor and
solution pump.
2. DISCONNECT THE POWER CORD.
3. Move the machine to designated waste water “DISPOSAL SITE” (Such as a sink, floor
drain, or bucket).
4. Disconnect the Hose Assembly from the machine.
5. Tip the Recovery Tank upright and drain the dirty solution through the hose connection port
on the top rear of the machine.
6. Tip the Solution Tank and drain unused water or solution. Thoroughly rinse the tank if any
cleaning chemical was used.
7. Check and clean lint filter on inside center of recovery tank. Pull filter up and out, rinse
clean and be sure to replace the filter element.