PSC1502 AUDIO SYSTEMS
INSTALLATION GUIDE
HAWG WIRED
PAGE 13
NEWARK, CA
U
U
S
S
E
E
R
R
G
G
U
U
I
I
D
D
E
E
[
[
C
C
O
O
N
N
T
T
I
I
N
N
U
U
E
E
D
D
]
]
TROUBLESHOOTING
INFRACTION
PROBABLE CAUSE
RESTITUTION
AMPLIFIER DOESN’T POWER UP
(LED IS OFF)
REM WIRE IS NOT G12V
TO THE AMPLIFIER
CHECK YOUR WIRING OF THE
REMOTE TURN-ON WIRE. MAKE
SURE THE TURN-ON SOURCE IS
PRO12V.
PWR WIRE IS NOT G12V
TO THE AMPLIFIER
CHECK THIS WIRE ALL THE WAY
TO THE BATTERY. MAKE SURE
THE IN-LINE FUSE IS INSTALLED
AND NOT BLOWN.
GND WIRE IS NOT GETTING
GROUND TO THE AMPLIFIER
MAKE SURE THE GROUND
LOCATION SELECTED IS
PROVIDING A GOOD, CLEAN
CHASSIS GROUND.
AMPLIFIER POWERS UP, BUT
MAKES NO SOUND (LED IS ON)
SPEAKER WIRES ARE NOT
CONNECTED OR SHORTED
CHECK YOUR WIRING FROM THE
AMPLIFIERS TO EACH SPEAKER
IN THE SYSTEM. MAKE SURE
THAT THE WIRE TERMINALS ARE
NOT SHORTING TO THE BIKE
CHASSIS OR OTHER WIRES.
INPUT FROM SOURCE UNIT NOT
CONNECTED PROPERLY
CHECK YOUR HIGH OR LOW
LEVEL INPUT WIRING FROM THE
SOURCE UNIT TO THE MAIN
AMPLIFIER.
SOURCE UNIT HAS NO OUTPUT
CHECK THAT YOUR SOURCE UNIT
IS FUNCTIONING PROPERLY.
REFER TO MANUFACTURER
INSTRUCTIONS IF NECESSARY.
SPEAKER OUTPUT SOUNDS LOW
OR DISTORTED
INPUT GAIN LEVEL SET
INCORRECTLY
SET THE GAIN LEVEL(S) USING
THE INSTRUCTIONS IN “TEST
AND TUNE”. IF YOU’VE ALREADY
COMPLETED THIS STEP, TRY
LOWERING THE GAIN SLIGHTLY
UNTIL THE DISTORTION STOPS.
LOW BATTERY CONDITION
CHECK YOUR BATTERY FOR
PROPER CHARGE AND REPLACE
IF NECESSARY.
