DAMAGE
Material damage due to mechanical damage
Protect the product from mechanical loads during assembly and installation, e.g. with cushioning.
5.1 Mechanical connection
WARNING
Lethal danger/malfunction from incorrectly installed hydraulic locking unit
Incorrectly installed hydraulic locking units or use of unsuitable line cross sections and connectors can
cause malfunctions, accidents, and irreversible or even fatal injuries.
►
Wear protective clothing.
►
Install the locking unit only in the manner and position specied.
►
Make adjustments to the angle to match the seat’s design on the base-side rod end only!
►
Do not adjust the angle as a means to change the length.
►
Keep all drilling chips, screws, and other foreign objects out of the ring gap between piston rod
and cylinder head.
►
Protect the piston rod from damage to its surface.
►
Only trained specialist personnel is permitted to assemble the hydraulic locking unit.
DAMAGE
Property damage from incorrectly installed hydraulic system
►
Assembly by trained specialists only.
►
Ensure that all labels and markings of the hydraulic system are easily visible and legible after
assembly.
►
Check installation space/connection points for damage.
1. Space required for assembly, installation and startup:
500x400x500 mm (WxHxD).
2. Transport the hydraulic locking unit safely to the installation site.
3. Make sure that the locking unit is not touching the seat structure or other ride components when
extended or retracted, or in any other position during operation.
The connection may only be made by the mounting points (ball joint).
4. Note the diameters of the rod eyes and rod ends:
Rod eye diameter in rod end 15: Ø 15
-0.008mm
Rod eye diameter in rod end 17: Ø 17
-0.008mm
22/63
B 6052-21 -
11
-2021 - 1.7
HAWE Hydraulik SE
