ENGLISH
17
1. Inspect the air-powered impact wrench prior to each use in order to:
a) ensure that the proper power source is being used;
b) verify that the tool is in proper working order.
2. Do not use a tool that is not in proper working order.
3. Do not use oxygen or any other combustible or bottled gas to power this tool.
4. Do not use this tool in the presence of flammable liquids or gases.
5. Only use sockets that are specifically designed for use with this air-powered
impact wrench.
6. Verify that the air valve (or trigger) on the air-powered impact wrench is in the “off”
position before connecting the air-powered impact wrench to the air supply.
7. This impact wrench requires an air pressure of 90 PSI and air flow according to
the specifications that appear at the beginning of this Manual.
8. Drain the air tank daily. Water in the air line will damage the air-powered impact
wrench.
9. Clean the air inlet filter weekly.
10. The pressure in the line should be increased in order to compensate for an
unusually long air hose (longer than 26’ [8 m]). The diameter of the hose should
be 3/8” (10 mm) ID.
11. Keep the hose away from heat, oil, and sharp edges. Check the hose for wear,
and verify that all connections are secure.
12. Do not use the air-powered impact wrench for a task that it is not designed to
perform.
13. Do not use air-powered impact wrench if it is damaged or if there is reason to
believe that it is defective.
14. Do not use air-powered impact wrench without having been instructed in its use by
a qualified person.
15. Do not carry the air-powered impact wrench by the air hose.
This HAUSSMANN air-powered impact wrench features a single-hammer mechanism
for higher torque. It also features an adjustable (3 positions) torque regulator. It is
designed for removing and installing nuts and bolts and automotive lug nuts on tires,
and for general assembly work.
Square Drive: 1/2” (13 mm)
Bolt capacity: 5/8" (16 mm)
No-load Speed: 7000 RPM
Maximum Torque: 230 ft-lb
Average Air Consumption: 5 PCM @ 90 PSI
Operating Pressure: 90 PSI
Air Inlet Size: 1/4” (6 mm) NPT
Air Hose: 3/8” (10 mm) ID
ACCESSORIES
1/4” NPT (male) connector
IMPORTANT SAFETY INSTRUCTIONS FOR AIR-POWERED IMPACT WRENCH
SPECIFICATIONS
