17
ENGLISH
SPECIFICATIONS
SETUP
AIR SOURCE
The HAUSSMANN nailer/stapler is designed to operate on clean, dry,
compressed air, regulated at 60-100 PSI (41 to 690 kPa / 4.1 to 6.9 bar). The
preferred system would include a filter, a pressure regulator, and an automatic
oiler located as close to the tool as possible. Within 15 feet (5m) is ideal. Do not
use bottled air or gases. Please see below:
All compressed air contains moisture and other contaminants that can harm the
internal components of the tool. An air line filter will remove most of these and
significantly prolong the life of the tool. Ensure the in-line oiler has sufficient oil.
If an in-line oiler is not available, place 2 drops of oil into the tool’s air inlet at
the beginning of each workday. More than this will be expelled from the tool’s
exhaust during firing.
Air fitting
: The nailer/stapler should be equipped with a 1/4” NPT male ‘quick
connector’. To prevent accidental cycling even though disconnected, the tool
must always be connected to the air supply in such a way that all air pressure in
it is released when the coupling is disconnected.
Air hose
Filter
Oiler
Regulator
Nailer / Stapler
Quick connector
Air supply
fig. 1
fig. 2
Operating pressure (min. to max.): 60-100 PSI
Air consumption: 4-5 CFM @ 80 PSI
Air inlet: 1/4” NPT
Padded hand grip.
Belt loop hook.
Adjustable exhaust deflector.
Tool weight: .4 lbs (1.5 kg)
Pkg. weight: 4.0 lbs (1.8 kg)
OPERATING PROCEDURES
UNPACKING THE TOOL
Check and make sure one of each of the following are all included.
Combination Nailer Stapler
S hex key
S4 hex key
Small bottle of air tool oil
Operating instructions
