A
OPERATING INSTRUCTIONS
16
SPECIfICATIONS
rated voltage: .................................120V~60Hz
rated current: ............................................4.0 A
No load speed: .................................9000 rPM
Max.cutting diameter: ...................................12”
Diameter of line: .......................................0.065”
Line length:......................................2*10’(2*3m)
Weight: ....................................................6.2 lbs
Protection class: ......................................... /II
COMPONENT LIST
1.Trigger switch
2.Auxiliary handle
3.Handle rotation locking mechanism
4.Height adjustment locking mechanism
5.Telescope tube
6.Flattening head adjustment button
7.Motor housing
8.Edge guide
9.Cutting head assembly
10.Guard
11.Cable strain relief arm
12.Mains supply cable
13.Line cutter (See B)
14.Spool head bump feed mechanism
15.Spool head cover
16.Cutting line
17.Locking mechanism (on both sides)
ACCESSORIES
Edger wire
Auxiliary handle
Safety guard
We recommend that you purchase your
accessories from the same store that sold you
the tool. Use good quality accessories marked
with a well-known brand name. Choose the
type according to the work you intend to
undertake. refer to the accessory packaging
for further details. Store personnel can assist
you and offer advice.
NOTE: Before using the tool, read the
instruction book carefully.
ASSEMBLY / ADJUSTMENT
1. fitting the guard (See fig A)
Locate the guard to the motor housing, note
orientation. Secure in place using four screws
supplied. Check the guard is properly located
and secure.
Figure A
Take great care when doing this as the guard
has a very sharp cutting edge. (See fig B)
Summary of Contents for 8401022
Page 23: ...23 A ...
