Haussmann 59695030, Operator'S Manual

Page: 31 / 40

31
EN
in hand injuries. Wear protective gloves
when starting the equipment.
Connecting tools to the generator
Connect the equipment you want to use to
the socket-outlets (3/4)
IMPORTANT!
- These sockets may be loaded
continuously (in S1 mode) and temporarily
(in S2 mode).
- Do not connect the generator to the
domestic power network as this may result
in damage to the generator itself or to other
electrical appliances in your home.
Note: Some electrical appliances (power
jigsaws, drills, etc.) may have a higher level
of power consumption when used in difficult
conditions.
Switching off the engine
- Before you switch off the generator, allow
it to run briefly with no consumers so that it
can "cool down”.
- Move the ON/OFF switch (12) to position
"O”.
- Close the oil cock.
Overload cut-out for socket-outlets
Important! The generator is fitted with an
overload cut-out.
This shuts down the sockets (3/4). You can
restart the sockets (3/4) by pressing the
overload cut-out (7).
IMPORTANT! If this happens, reduce
the electric power you are taking from
the generator or remove any defective
connected appliances.
IMPORTANT! Defective overload cut-outs
must be replaced only by overload cut-
outs of identical design and with the same
performance data. If repairs are necessary,
please contact your customer service
centre.
OPERATING INSTRUCTIONS