– 14 –
9.
Bag “I” -
Mount the pedal (1) to the caster bracket
(2) by using the longest bolt (3) and nut (4), and
attach the link (5) to pedal (1) with bolt (6) and nut (4)
by 6 mm hex key supplied.
Fig. F
10.
Bag “I” -
Attach the left / right rear tubes (8) of caster
bracket into the brackets (9) of the rear legs by
using two short bolts (10). Attach the link (5) into the
bracket (11) with bolt (6) and nut (4).
NOTE:
Do not over tighten bolts. The caster
assembly will be difficult to operate if the bolts are
too tight.
Fig. G
NOTE:
The front right / left legs have been removed
from this drawing for illustration purposes only.
11.
Bag “J, K” -
Attach mitre gauge storage (12) to the
right leg support by using two short screws (14) and
nuts (15).
Fig. H
12.
Bag “J, K” -
Attach power cord storage (16) to the
left leg support by using two long screws (18) and
nuts (15).
9
8
10
6
11
4
5
13.Insert the rip fence storage (20) into slots (21) of the
left leg support, tighten by using two of six screws
(22).
Fig. I
NOTE:
Make sure all screws and nuts are tight and
stand is on a stable surface before mounting saw.
Although compact, this saw is heavy and should be
lifted with care. Get the assistance of someone to lift
and move the saw.
For your safety, never connect plug to power source
receptacle until all assembly and adjustment steps are
complete, and you have read and understood the safety
instructions.
ASSEMBLING TABLE SAW TO STAND (FIG. J)
1. Lift the saw body (1) and place on the stand (2), align-
ing the mounting grooves (3) of the saw base with the
four mounting holes on the top plate of stand.
2.
Bag “P” -
Attach the table saw to the stand with four
hex head bolts (4).
3. Tighten all mounting bolts with a wrench.
Fig. J
OPERATING ONE STEP CASTER STAND SYSTEM
(FIG. J)
1. Step on the bottom of pedal (5) with your foot to lift
saw off ground. Make sure pedal locks in place.
2. Move saw to the desired location.
3. Press against the top of pedal (6) with your foot to
release the pedal and lower the saw to the ground.
NOTE:
Table Saw assembly is heavy, make sure the
ground is level and free of obstructions.
WARNING
!
4
3
1
2
5
6
WARNING
!
14
12
15
21
16
18
22
20
15
5
6
3
2
4
1
4
right side
view
