PNT108
ENGLISH
18
MAINTENANCE & STORAGE
STORAGE
If it is necessary to store the tool for an extended period of time, apply a generous
amount of lubrication before storing. The tool should be run for approximately 30
seconds in order to ensure that the lubrication is evenly distributed throughout the tool.
The tool should be stored in a clean and dry environment.
TROUBLESHOOTING
!
!
WARNING:
If any of the following symptoms appears while operating the tool, stop
using the tool immediately, or serious personal injury could result. Only an authorized
service centre should perform repairs on this tool. Disconnect the electrical plug and
disconnect any tools from air supply before attempting any adjustment.
NOTE:
Troubleshooting problems may have similar causes and solutions.
SERVICE
INTERVAL
Lubricate the tool
If the tool is used without an in-line lubricant then be sure
to put in about 3 drops of lubricant at the start of each
workday and 3 drops at each 30 minutes of use
thereafter.
Daily & every
30 minutes of
use thereafter
Cleaning
Wipe tool clean and inspect tool for wear or damage.
Use non-flammable cleaning solutions to wipe the tool.
Never soak the tool in these solutions as they can
cause internal damage.
Each use
Tighten Screws
Always ensure that all of the screws are kept tight as
loose screws can cause injury or can damage the tool.
Check each
usage.
Tighten as
necessary.
MAINTENANCE TASK
DESCRIPTION /REASON
4. Check the level of lubrication in the gearbox by removing the set-screw
that is located under the tool head, and top it up if necessary.
5. A loss of power or erratic action may be due to the following:
a) Excessive drain on the air line; moisture or restriction in the air pipe;
incorrect size or type of hose connectors. To remedy these situations, verify
the air supply and follow instructions.
b) Grit or gum deposits in the air-powered heavy duty ratchet wrench may
also reduce performance. If the air-powered ratchet wrench has an air strainer
(located in the area of the air inlet), remove the strainer and clean it.
6. When the air-powered heavy duty ratchet wrench is not in use, disconnect it
from the air supply, clean it, and store it in a safe, dry, and childproof location.
