19
TROUBLESHOOTING
WARRANTY
Thank you for investing in a HAUSSMANN XPERT power tool. These products have
been made to demanding, high-quality standards and are guaranteed for domestic use
against manufacturing faults for a period of 36 months from the date of purchase.
This guarantee does not affect your statutory rights. In case of any malfunction of your
tool (failure, missing part, etc.), please contact one of our service technicians at our toll
free service line at 1-866-206-0888 from 8 AM to 6 PM, Monday to Friday, Eastern
time. RONA reserves the right to repair or replace the defective tool, at its discretion.
The product is guaranteed for 36 months if used for normal trade purposes. Any
guarantee is invalid if the product has been overloaded or subject to neglect, improper
use or an attempted repair other than by an authorized agent. Heavy-duty, daily
professional or hire usage are not guaranteed. Due to continuous product
improvement, we reserve the right to change the product specification without prior
notice.
REGISTER YOUR PRODUCT
We invite you to register your product online to make future communications easier.
To do so, simply visit our website www.haussmanntools.com.
SYMPTOM
PROBABLE CAUSE
CORRECTIVE ACTION
The tool runs at normal
speed, but loses power
under load.
Motor parts are worn.
The cam clutch is worn or
sticking due to insufficient
lubrication.
Lubricate the clutch housing.
Check for excess clutch oil. Clutch cases should only be
filled halfway. Overfilling may cause drag on high-speed
clutch parts. A typical oiled/lubricated wrench requires
1⁄2 oz (1.5 ml) of oil.
GREASE/LUBRICATION NOTE: Heat usually indicates
insufficient grease in the chamber. Harsh operating
conditions may require more frequent lubrication.
The tool runs slowly. The
air flows slightly from the
exhaust.
Dirt particles have gotten
jammed in the motor.
The power regulator is in
the closed position.
The air flow is blocked by
dirt.
Check the air inlet filter for blockage.
Pour air tool lubricating oil into the air inlet, as per
instructions.
Operate the tool in short bursts, quickly reversing
rotation back and forth, where applicable.
Repeat above as needed.
The tool will not run. The
air flows freely from the
exhaust.
One or more of the motor
vanes is stuck due to
material build-up.
Apply air tool lubricating oil into the air inlet.
Operate the tool in short bursts, quickly reversing
rotation back and forth, where applicable.
Tap the motor housing gently with a plastic mallet.
Disconnect the air-powered ratchet wrench from the air
supply. Free the motor by rotating the drive shank
manually, where applicable.
The tool will not shut off.
The throttle valve O-rings
have dislodged from the
seat in the inlet valve.
Replace the O-rings.
