SKU 95419
For technical questions, please call 1-800-444-3353.
PAGE 9
14.
Attach the Grease Fitting (31) to the Hub (18). Carefully slide a Hub over the
spindle at each end of the Axle (16). Follow the directions on Bearing Packing
on the last page of this manual. Insert the Outer Bearings (20) onto the spindles
of both ends of the Axle. Insert the 3/4” Flat Washer (N) onto each spindle of the
Axle. Then secure the Hub and Bearing assemblies, using the Castle Nuts (K).
(See Figure G, next page.)
15.
NOTE: Back the Castle Nuts (K) off slightly so the Tires (19) can just move
freely. Insert a Cotter Pin (O) through the hole in the ends of the spindles of the
Axle (16) and spread the Cotter Pins.
(See Figure G.)
16.
Press each Dust Cap onto each Hub (18).
(See Figure G.)
17.
Place a Tire/Wheel Assembly (19) onto each Hub (18). Secure each Tire/Wheel
assembly firmly to the Hubs, using the Lug Nuts (J)
NOTE: Make sure the Lug Nuts are torqued to at least 90 Ft.-Lbs.
18.
With assistance, extend the Trailer Bed to full length by lifting the upper section
180 degrees towards the rear of the Trailer.
(See Figure H, page 11.)
19.
Attach the Coupler (7) to the Coupler Base (6), using a 3/8” x 3-1/2” Bolt (W).
Lock the Coupler Trigger with the Safety Pin (29). Then, insert the “R” Pin (S)
FIGURE F
