Hatteland JH 15T17 MMC series, User Manual

Page: 24 / 66

Physical Connections - MMC / xxC based units
24
IND100133-39
DVI-I OUT :
DVI/RGB OUT enables a direct clone signal output from the computer. You may choose to use a DVI-I 29P cable
directly or use a DVI-I -> RGB adapter to use a RGB/VGA HD D-SUB 15P instead for this purpose. Connect the cable
to the Connector (female) and secure it to the hex spacers provided on the unit. Connect the other end to your
equipment and secure it.
LPT1 Parallel Port INPUT/OUTPUT:
Standard LPT1 Printer/Parallel (Bi-Directional/EPP/ECP) port using a D-SUB 25P Female
connector. Fasten the cable to the connector using the provided screws on the cable housing itself.
CompactFlash Reader:
CompactFlash Reader supports Type I & II cards. Insert the card gently into the slot with the logo facing towards the
TFT display (only when the unit is off). The card is removed by pressing the EJECT button next to the card slot. A wide
range of card sizes are supported.
NOTE: DO NOT ATTEMPT TO REMOVE THE FLASH CARD WHILE THE UNIT IS OPERATING!
This is based on that the CF Slot has been configured to operate as a IDE device. If the Flash Card is removed
from the slot while the unit is on, data may be lost or partly corrupted.
COM1,2 Serial Port INPUT/OUTPUT:
Supports RS-232/422/485 opto-isolated using D-SUB 9P Male connectors. Fasten the cable to the connector using
the provided screws on the cable housing itself.
POWER INPUT: (For units supporting AC input)
The internal AC power module supports both 115VAC/60Hz and 230VAC/50Hz power input.
Please check specifications for your unit.
+ -
POWER INPUT: (For units supporting DC input)
Connect your DC power cable to the 2P Amphenol FCC17 D-SUB Connector (male). Secure the cable to the hex
spacers provided on the unit, and secure the other end to your power supply. The internal DC power module supports
24VDC. Please check specifications for your unit.
PCI Slot:
The unit features 1 x miniPCI slot. Cards mounted inside are normally installed from factory. The unit requires external
modfication of input/output terminal plate to gain access to connectors from the PCI card. Conventional PCI 1.x/2.x
cards is not suppported.