Hatteland JH 10T08 MMC, User Manual

Page: 19 / 60

Physical Connections - MMC based models
19
INB100014-1 (Rev 27)
IND100133-36
LPT1 Parallel Port INPUT/OUTPUT:
Standard LPT1 Printer/Parallel (SPP/EPP/ECP) port using a D-SUB 25P Female connector.
Fasten the cable to the connector using the provided screws on the cable housing itself.
PS/2 Keyboard and PS/2 Mouse INPUTS:
Connect the PS/2 keyboard cable to the PS/2 5P Connector (female) marked with KEYBOARD.
Connect the PS/2 mouse cable to the PS/2 5P Connector (female) marked with MOUSE.
CompactFlash Reader:
CompactFlash Reader supports Type I & II cards. Insert the card gently into the slot with the logo
facing towards the TFT display (only when the unit is off). The card is removed by pressing the
EJECT button next to the card slot. A wide range of card sizes are supported.
NOTE: DO NOT ATTEMPT TO REMOVE THE FLASH CARD WHILE THE UNIT IS OPERATING!
This is based on that the CF Slot has been configured to operate as a IDE device. If the Flash Card is removed from the slot while the unit
is on, data may be lost or partly corrupted.
USB1,2,3 INPUT/OUTPUT:
Supports any USB1.1 (12Mbps) or USB2.0* (480Mbps) compliant peripherals. Drivers for most
USB devices are useally included in operating system or on separate installation CD’s delivered
with product. USB 1.1 devices will operate in USB 1.1 mode (12 Mbps)
*Note: USB2.0 may not be supported on all MMC ETX models. Please review the specifications.
Power INPUT: (AC or DC Model)
AC MODEL ONLY:
The internal AC power module supports both 115VAC/60Hz and 230/50Hz power
input using a standard IEC European power plug.
DC MODEL ONLY:
Secure the cables (check polarity!) to the screw terminal. The internal DC power
module supports 24 VDC.