Hatteland JH 10T08 MMC, User Manual

Page: 17 / 60

17
INB100014-1 (Rev 27)
IND100078-10
General Installation Recommendations
Installation
Maximum Cable Length
The RGB/DVI cable should generally be kept as short as possible to provide a high quality output
on the display. The maximum cable length will depend on the signal resolution and frequency, but
also on the quality of the signal output from the computer. Recommended is 60Hz vertical
frequency.
Cables up to 10 meters generally provides good picture quality even with a 1600x1200 (UXGA)
60Hz signal. In most cases (especially with lower resolutions) even longer cables will provide a
satisfactory result. This should however be tested in advance before making the decision on how
far the unit can be placed from the signal source.
Standard Bracket
When mounting the bracket on the MMC products, USE only the provided bracket kit. Using any
other or longer bolts may/or will do serious damage to components inside the product, and will
void warranty! Use a Allen Wrench tool to fasten the middle bolts.
Please see the Technical Drawings section in this manual for additional information.
Provided kit consists of:
4 pcs of RenCol Tristar Knob Male - M6x10 mm
4 pcs of MicroPlastic - 6mm Nylon washer.
4 pcs of Bolt with shoulder washer - M6x1x20mm
4 pcs of Flat washer
Mount the bracket with the center bolt and washers
on each side.
Mount the Tristar bolts on each side.
Adjust the tilting angle and secure all bolts.