7. Attach CROSSBEAM, P8, with cutout opening facing down and to the left, using (2) SCREWS, H1, and pre-drilled
holes on each side, as shown in Figure 3.
8. Attach LEFT and RIGHT FRONT LEGS, P1L and P1R, using (2) BOLTS, H2, and (2) WASHERS, H3, on each leg, as
shown in Figure 3.
Note: Hand tighten for now, and then do final tightening with ALLEN WRENCH, T1, once P4 Spreader
is attached in next step.
9. Attach SPREADER, P4, using (4) SCREWS, H1, as shown in figure 3.
Note: Hand place screws in all four pre-drilled
holes to align panel before tightening.
CAUTION:
P4 SPREADER MUST BE CENTERED
CORRECTLY ONTO PRE-DRILLED HOLES
IN LEGS BEFORE ATTACHING WITH H1
SCREWS.
Figure 3
NOTE: Location
of gear hinge
H1
H1
H1
H2
H3
P4
P8
P1L
P1R
ASSEMBLY INSTRUCTIONS (CONT.)
6
