Form No. TM2M_CN-0617
7
English
OPERATION
General
The Electric Conveyor Toaster is designed for ease of operation.
Perform the following procedure to operate the toaster.
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.
CAUTION
Always operate toaster with crumb tray installed.
1. Plug the unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. See
the SPECIFICATIONS section for details.
2. Move the feed ramp to the desired position.
• For automatic feeding, move the feed ramp to the
automatic feed position. Bread products enter the
toaster by placing them on the feed ramp and releasing.
• For manual feeding, rotate the feed ramp up until it
rests on top of the unit. Bread products can be loaded
manually by placing directly on the conveyor belt.
Automatic Feed
Position
Manual Feed
Position
Toast Feed Ramp
3. Move the selector switch to the desired toasting setting.
• To toast both sides of the bread, place the selector
switch in the BREAD position.
• To toast the top of the bread only, place the selector
switch in the BUN position.
NOTE: The Power ON (I) Indicator Light will glow after a
toasting selection is made.
4. Turn the Color Control knob to the lightest position while
the unit heats up.
NOTE: Allow approximately 15 to 20 minutes for a warm-up
period.
CAUTION
BURN HAZARD: Some exterior surfaces on unit will get
hot. Use caution when touching these areas.
5. After warm-up period, set the Color Control knob to the
medium position and toast two slices of bread product then
re-adjust the Color Control knob to the desired setting.
NOTE: To toast moist products such as English muffins, rye
bread, or whole wheat, slow the conveyor by turning
the Color Control knob to a darker setting (clockwise).
All TM series toasters can be put into a Power Save mode by
placing the selector switch in the STBY (standby) position. The
toaster is operating at 25% power in the Power Save mode.
NOTE: To place toaster back into full operation, turn the
selector switch to the BREAD or BUN position. Unit is
back up and ready for toasting within 5 minutes.
CAUTION
Toasting of coated or buttered products such as garlic
bread, cheese sandwiches, and sweet rolls is NOT
recommended. Residue will reduce toaster performance
and could ignite inside toaster. Using toaster with the food
products listed above will void unit warranty.
Selector Switch
COLOR CONTROL
Knob
Power ON (I)
Indicator
Light
Control Panel
