![background image](http://html1.mh-extra.com/html/hatco/glo-rite-hl-18/glo-rite-hl-18_installation-and-operating-manual_2107044008.webp)
Form No. HLCEM-0414
8
OPERATION
General
Display Lights are designed for maximum durability and
performance with minimum maintenance.
ELECTRIC SHOCK HAZARD:
• Turn OFF power at fused disconnect switch/circuit
breaker and allow unit to cool before performing any
cleaning, adjustments, or maintenance.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Do not clean unit when it is energized or hot.
• Do not steam clean or use excessive water on unit.
• This unit is not “jet-proof” construction. Do not use jet-
clean spray to clean this unit.
This unit has no “user-serviceable” parts. If service is
required on this unit, contact an Authorized Hatco Service
Agent or contact the Hatco Service Department at
414-671-6350; fax 414-671-3976.
WARNING
Daily Cleaning
To preserve the finish of the unit as well as maintain
performance, it is recommended that the unit be cleaned daily.
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch finish of unit, marring
its appearance and making it susceptible to soil
accumulation.
1. Turn off the unit and allow it to cool completely.
2. Wipe down all metal surfaces using a
soft, clean, damp
cloth
. Stubborn stains may be removed with a non-
abrasive cleaner. Hard to reach areas should be cleaned
with a small brush and mild soap.
Replacing a Display Light Bulb
Use the following procedure to replace a light bulb. To order
replacement incandescent light bulbs, use Hatco P/N
02.30.043.00 for 120 V bulbs or P/N 02.30.058.00 for 240 V
bulbs.
Use only light bulbs that meet or exceed National
Sanitation Foundation (NSF) standards and are specifically
designed for food holding areas. Breakage of light bulbs
not specially-coated could result in personal injury and/or
food contamination.
1. Turn off the unit, disconnect from the power circuit, and
allow the unit to cool.
2. Bulbs have a threaded base. Unscrew the light bulb from
the unit and replace it with a new specially coated
incandescent bulb.
WARNING
NOTICE
General
Use the following information to operate a Display Light.
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.
Standard and approved manufacturing oils may smoke up
to 30 minutes during initial startup. This is a temporary
condition. Operate unit without food product until smoke
dissipates.
Startup
1. Move the Power I/O (on/off) switch to the I (on) position.
The display lights will illuminate.
WARNING
CAUTION
Shutdown
1. Move the Power I/O (on/off) switch to the O (off) position.
2. Perform the “Daily Cleaning” procedure in the
MaINTENaNCE section of this manual.
Controls
Power I/O
(on/off) Switch
MAINTENANCE