Form No. GRCMWDHHIM-0907
10
MAINTENANCE
Removing and Installing Side Glass Panels
Side glass panels are removable for cleaning.
1. Loosen thumbscrew above panel and tilt glass
forward, then carefully lift panel out of bottom rail.
2. Clean glass.
3. To install repeat step one in reverse order.
Removing and Installing Lower Pan Skirt
1. Remove water reservoir cover.
2. Lift pan skirt up and remove from bottom shelf.
3. Clean shelf area and pan skirt.
4. To install the lower pan skirt repeat 1 and 2 in
reverse order.
Removing and Installing Upper Pan Skirt
1. Lift pan skirt and remove from top shelf.
2. Clean shelf area and pan skirt.
3. To install upper pan skirt repeat 1 and 2 in
reverse order.
NOTICE
Use only non-abrasive cleaners. Abrasive
cleaners could scratch the finish of your unit,
marring its appearance and making it
susceptible to dirt accumulation.
CLEANING
The Hatco Glo-Ray
®
Merchandising Warmer is
designed for maximum durability and performance,
with minimum maintenance.
WARNING
To avoid any injury, turn the power switch OFF
on the unit and unplug the unit from the power
source and allow to cool completely before
performing any maintenance or cleaning.
WARNING
Unit is not waterproof. DO NOT submerge in
water. To prevent any injury or damage do not
operate if unit has been submerged in water.
WARNING
To avoid electrical shock or personal injury, do
not steam clean or use excessive water on the
unit.
CAUTION
To avoid any injury or damage to the unit, do not
move or relocate the unit for cleaning.
To preserve the finish of the Glo-Ray Merchandising
Warmer, the following is recommended:
• Metal surfaces to be wiped daily with a damp
cloth. (Stubborn stains may be removed with a
good stainless steel cleaner or a non abrasive
cleaner.)
• Hard to reach areas should be cleaned with a
small brush and mild soap.
• The glass side and rear panels should be
cleaned with ordinary glass cleaner and a damp
soft cloth or paper towel.
NOTE: Do not remove rear glass panel for cleaning.
Clean rear glass panel while installed in frame.
• The polycarbonate door(s) and breath protector
should be cleaned with a mild, soapy water
solution and a damp, soft cloth.
NOTICE
DO NOT use paper towel or glass cleaner to
clean polycarbonate breath protector. Paper
towel and glass cleaner may scratch the
material. Wipe off breath protector using a soft,
clean and damp cloth.
