Form No. GRJWM-0406
4
INSTALLATION
UNPACKING
Glo-Ray
®
Fried Product Holding Warmers are
shipped with most components pre-assembled.
Care should be taken when unpacking shipping
carton to avoid damage to unit and components
enclosed.
WARNING
To avoid any injury or damage to the unit do not
pull unit by power cord.
WARNING
To prevent any injury, discontinue use if power
cord is frayed or worn.
1. Remove unit from box.
2. Remove information packet.
To prevent delay
in obtaining warranty coverage, fill out and
mail in the warranty card.
3. Remove tape and protective film from all
surfaces of unit.
4. The GRJW-3 and GRJW-4 series units are
supplied with pan dividers. To install them, place
the dividers in the channels provided. (See
Figure 4.)
LOCATION
NOTE: Unit must be transported in the upright
position.
For proper operation and maximum performance,
locate the Product Holding Warmer in an area
where the ambient air temperature is constant and
is a minimum of 70°F (21°C). Areas which are
susceptible to active air movements or currents
should be avoided, i.e., near exhaust fans or hoods
and air conditioning ducts.
CAUTION
Unit is not weatherproof. For safe and proper
operation locate the unit indoors where the
ambient air temperature is a minimum of
70°F (21°C).
Figure 4. Installing Pan Dividers
CAUTION
For safe and proper operation, the unit must be
located a reasonable distance from combustible
walls and materials. If safe distances are not
maintained, discoloration or combustion could
occur.
CAUTION
Locate the unit at the proper counter height, in
an area that is convenient for use. The location
should be level to prevent the unit or its
contents from accidentally falling, and strong
enough to support the weight of the unit and
food displayed.
Summary of Contents for GLO-RAY GRJW Series
Page 14: ...Form No GRJWM 0406 12 NOTES ...
Page 15: ...Form No GRJWM 0406 13 NOTES ...
