background image

Form No. GRS2GM-0420

3

WARNING

FIRE HAZARD: Do not use harsh chemicals such as 

bleach (or cleaners containing bleach), oven cleaners, or 

flammable cleaning solutions to clean this unit.
Units not installed properly could tip over, resulting in 

personal injury and/or damage to unit.
Make sure food product has been heated to the proper 

food-safe temperature before placing in unit. Failure to 

heat food product properly may result in serious health 

risks. This unit is for holding preheated food product only.
Hatco Corporation is not responsible for actual food 

product serving temperature. It is the responsibility of the 

user to ensure that food product is held and served at a 

safe temperature.
Make sure all operators have been instructed on the safe 

and proper use of the unit.
This unit is not intended for use by children or persons 

with reduced physical, sensory, or mental capabilities. 

Ensure proper supervision of children and keep them away 

from the unit.
This unit has no “user-serviceable” parts. If service 

is required on this unit, contact an Authorized Hatco 

Service Agent or contact the Hatco Service Department at  

800-558-0607 or 414-671-6350.

CAUTION

BURN HAZARD: Some exterior surfaces on unit will get 

hot. Use caution when touching these areas.
Locate unit in an area that is convenient for use. The 

location should be level and strong enough to support the 

weight of the unit and contents.

NOTICE

Do not lay unit on front or back side. Damage to unit could 

occur.
Use non-abrasive cleaners and cloths only. Abrasive 

cleaners and cloths could scratch finish of unit, marring its 

appearance and making it susceptible to soil accumulation.

WARNING

ELECTRIC SHOCK HAZARD:

  •  Plug unit into a properly grounded electrical receptacle 

of the correct voltage, size, and plug configuration. If 

plug and receptacle do not match, contact a qualified 

electrician to determine and install proper voltage and 

size electrical receptacle.

 • Turn OFF power switch, unplug power cord, and 

allow unit to cool before performing any cleaning, 

adjustments, or maintenance.

  •  DO NOT submerge or saturate with water. Unit is not 

waterproof. Do not operate if unit has been submerged 

or saturated with water.

  •  Unit is not weatherproof. Locate unit indoors where 

ambient air temperature is a minimum of 70°F (21°C).

  •  Do not clean unit when unit is energized or hot.
  •  Do not steam clean or use excessive water on the unit.
  •  This unit is not “jet-proof” construction. Do not use 

jet-clean spray to clean this unit.

  •  Discontinue use if power cord is frayed or worn.
  •  Do not attempt to repair or replace a damaged power 

cord. Cord must be replaced by an Authorized Hatco 

Service Agent or a person with similar qualifications.

  •  Do not allow liquids to spill onto unit.
  •  This unit must be serviced by qualified personnel only. 

Service by unqualified personnel may lead to electric 

shock or burn.

  • Use only Genuine Hatco Replacement Parts when 

service is required. Failure to use Genuine Hatco 

Replacement Parts will void all warranties and may 

subject operators of the equipment to hazardous 

electrical voltage, resulting in electrical shock or burn. 

Genuine Hatco Replacement Parts are specified to 

operate safely in the environments in which they are 

used. Some aftermarket or generic replacement parts 

do not have the characteristics that will allow them to 

operate safely in Hatco equipment.

IMPORTANT SAFETY INSTRUCTIONS

Read the following important safety information before using this equipment to avoid serious 

injury or death and to avoid damage to equipment or property.

Summary of Contents for Glo-Ray 2-Go GRS2G Series













Reviews: