Form No. HDMM_CN-0111
7
INSTALLATION
English
4. Plug the power cord on the unit into the electrical
receptacle.
5. Partially insert the unit into the opening, making sure the
power cord is fed into the opening first.
6. Before installing the unit into the opening completely, apply
a bead of National Sanitation Foundation-approved sealant
between the drawer warmer flange and the cabinet facing.
7. Slide the unit into the opening until the front locking studs
drop behind the locking strip. To verify installation, pull out
bottom drawer completely and gently pull to ensure the unit
is locked in place.
Figure 9. Built-In Installation
Drawer
Warmer
Flange
Locking
Strip
Cabinet
Facing
Locking Studs
(underneath)
Installing HDM-2B Models
HDM-2B models are built-in units that require installation into a
cabinet before operation.
1. Cut the appropriate opening in the cabinet. refer to the
illustration below for dimensions.
Figure 8. Cutout and Locking Strip Dimensions
NOTE: Maintain a minimum clearance of 25 mm (1") between
the cutout opening and the floor.
2. Fasten a locking strip (not supplied) to the lower front
inside lip of the cabinet opening.
3. Make sure a properly grounded electrical receptacle of the
correct voltage, size, and plug configuration is installed
inside the cabinet cutout. See the SPeCIFICaTIONS
section for details.
721 mm
(28-3/8″)
25 mm
(1″)
489 mm
(19-1/4″)
603 mm
(23-3/4″)
Front View
Side View
22.2 mm
0.875″
3.2 mm
0.125″
Locking
Strip
Locking
Strip
Summary of Contents for Drawermax HDM Series
Page 20: ...15 20 HDMM_CN 0111 20...
Page 22: ...Form No HDMM_CN 0111 22 NOTES English...
