ASSEMBLY AND INSTALLATION
Note: Turn the belt adjustment screw-heads in end-cover using 8 mm hexagon wrench to adjust the belt as shown in the
above
Adjustment with T-Wrench and movement change of belt and roller
Belt Section
Wrench movement
Roller shaft movement
Side-drifting
Left
(Fig. 1)
w
Left side backward
To the right
Counterclockwise
Left side forward
To the left
Right
(Fig. 2)
Clockwise
Right side backward
To the left
Counterclockwise
Right side forward
To the right
Adjustment of Tension
It is adjustment of distance between front and back rollers to obtain optimal tension of
the belt which is necessary to prevent slipping of the belt during running.
1.
Turn the power on.
2.
Operate the machine at 4km/h.
3.
Holding the handgrip, push the belt with foot to the opposite direction of
running. If the belt momentarily stops (slips), then adjustment is necessary.
4.
Adjust belt tension turning the adjustment screws left or right using hexagon
wrench. Repeat the process until no slippage occurs.
Adjustment of Side-drifting
After the adjustment of belt tension, adjust side-drifting as
follows
1.
Increase the belt speed to 10 km/h.
2.
Adjust belt balance using 8mm hexagon wrench while
visually checking the belt for side-drifting.
3.
If no sign of side-drifting shows after 5 minutes, then
the balance of belt has been achieved. If side-drifting
occurs within 5 minutes, repeat the process until
balance is achieved.
4.
If necessary, talce out the motor and adjust belt balmce
by using 8mm L-wrench as shown in the picture
CAUTION: Do not turn the wrench without checking the
change in belt movement. Too much turning will push the
belt to one side and can damage it. It is recommended to
turn the wrench by 1/4 or by 1/8 revolution at a time for
precise adjustment.
12
