Page 5
If you experience problems adjusting the
damper after the break-in period contact your
dealer.
Pre-Lighting Instructions
When lighting your stove for the first time or any
time you have run out of pellets you will need to
fill the hopper with pellets. Pellets are fed from
the hopper to the burn pot by an auger.
A high
torque motor that is capable of doing
SERIOUS harm to fingers drives the auger.
Keep fingers and other objects away from the
auger.
WARNING: The auger can start at any time
while the stove is running
Air Intake Damper Positioning
NOTE:
In some cases the stove will operate
properly with the damper almost fully closed.
Fully Closed
Fully Open
Figure 1. Air Inlet Damper
CAUTION: The ash cleanout rod must be
pushed in to operate the stove. (See ash shaker
rod in stove layout on page 1)
WARNING: The fire door and ash pan doors
must be in the latched position for the igniter
system to work!
The buttons on the board function as follows:
(Refer to Figure 2. The touch pad buttons are
labeled with the white numbers 1 through 5)
Figure 2. Control Box
1. The heat advance button (1) will advance the
setting between level 1 and 5. Once you reach level
5, it will drop back to level 1. Each level has a LED
light to indicate where the board is set.
2. The On/Off button (2) turns the stove on and
also acts as the toggle switch to reset the board after
the board switches to Diagnostic mode.
3. The auger button (3) will allow the customer to
manually auger pellets into the burn pot on start up
when needed.
4. The fan button (4) allows for adjusting the
Exhaust fan voltage on level 1 only. Push the button
and the LEDs flash once to decrease the voltage 5
volts. Push the button a second time and the LEDs
flash twice to decrease the voltage another 5 volts.
Pushing the button a 3
rd
time will reset the voltage to
the normal setting. This adjustment is only needed
when there is a problem with a chimney that has
excessive natural draft and the stove is going out on
the #1 setting because of too much draft.
