12
Wiring Diagram
1 Locate the tractor power/communication harness (006-6650TM(E)).
2 At the back of the tractor run the power leads to the battery.
3 Connect the red power wire with the 50 amp fuse to the positive side (12 volt) of the battery.
a. The power harness must be connected to the battery!
The unit will draw more amps than
convenience outlets can handle. Any modifications of the power harness will void systems
warranty. IF MODIFICATIONS ARE REQUIRED CONTACT HARVEST TEC FIRST!
b. This unit will not function on positive ground tractors.
c. If the unit loses power while operating it will not keep track of accumulated pounds of
product used and bale records.
4 Connect the black ground wire to frame of tractor or negative side of (12 volt) battery.
5 Connect the iPad Integration Control (030-6672C) to the Communication Harness (006-6650TM(E)).
6 Connect the orange wires and a
ttach the plug to the tractor’s ISOBUS port.
7 Connect the end to the Communication Harness (006-6650TM(E)) to the iPad Integration Control.
8 Connect the orange keyed power wires (006-5650K) and
attach the plug to the tractor’s ISOBUS port.
Pin Outs
Keyed Power Extension
006-5650K
Dual Channel
Processor (DCP)
006-6671LS
Moisture/Bale Rate
Harness
006-7303H(E)
Proximity Sensor (2X)
006-7303S
Star Wheel
Assembly (2X)
006-4641
End of Bale Sensor
006-7400
Optional Port
Terminating
Connector
006-5650Z
Active Terminator
from Baler Harness
Baler Interface Harness
006-6650VA (Non-UHD)
006-6650VAU (UHD Balers)
Orange Wire to
Keyed Power
Power/Comm Harness on Baler
006-6650LS2(E)
Data
Transfer
Baler
Connection
iPad Integration Control
030-6672C
AGCO 2100 Series Balers Pre 2012 need the
AGCO Integration Harness (006-6650VAX)
*Note: (E) indication is used
for International Dealers
Power/Comm Harness on Tractor
006-6650TM(E)