8
Wiring Diagram
A. Locate the tractor power/communication harness (006-6650TM(E)).
B. On the back of the tractor run the power leads to battery and the communication lead to ISOBUS plug.
C. Connect the red power wire with the 50 amp fuse to the positive side of the battery (12 volt).
a. The power harness must be connected to the battery!
The unit will draw more amps than
convenience outlets can handle. Any modifications of the power harness will void systems
warranty.
CONTACT HARVEST TEC IF MODIFICATION IS REQUIRED!
b. This unit will not function on positive ground tractors.
c. If the unit loses power while operating it will not record accumulated product used.
D. Connect the black ground wire to frame of tractor or negative side of battery (12 volt).
E. Connect the baler power and communication harness (006-6650LS) to the power port on the DCP and
to the display port on the DCP (006-6671RB).
F. Connect the Bluetooth Receiver (030-6672B) to the Communication Harness (006-6650TM(E)).
G. Install one terminating resistor to the pump controller connection on the DCP (006-5650Z).
H. Attach moisture cable (006-4640G3E) to the DCP.
Dual Channel
Processor
(DCP)
006-6671RB
Bluetooth Receiver
030-6672B
Optional Port
Data
Transfer
RB MC% Harness
006-4640G3E
End of Bale Sensor
006-7400
Power/Comm Harness on Baler
006-6650LS(E)
Power/Comm Harness on Tractor
006-6650TM(E)
Connect Orange
Key Power Wires
Terminating Connector
006-5650Z
Moisture Disc (2X)
006-4641HX
*Note: (E) indication is used
for International Dealers
