11
Common Questions
1. How do I turn the system on/off?
Turn the key in the tractor to the ON position. The ISOBUS Monitor will turn on, and the baler, on 600RB
working screen tabs, will be viewable. Turn the system off by turning the tractor key OFF.
2. How to get in the LBS/TON, MC%, and TONS/HR menus?
In the Main Menu press the SETUP MODE key. From this screen you can change your alarm settings and
bale rate settings. See SETUP INSTRUCTIONS in the Operations Manual for a detailed explanation of
this process.
3.
The moisture content displays “LO” or “HI” all the time.
When the moisture content display does not change frequently while baling, there is likely a faulty moisture
disc connection. Check all wires and connectors to see if there is a continuity or grounding problem.
4. Should the battery connections be removed before jump starting or charging a battery?
Yes. Anytime the tractor will have voltage going up rapidly the connections should be removed.
5. What is the moisture range of the moisture discs?
The Moisture discs will read moisture levels from 7% up to 60%.
6. Can dielectric grease be used when connecting harnesses?
Yes. Using dielectric grease will assist with good harness connections through the system.
7.
What do the lights on the 030-6672B indicate?
Blinking Lights
– System is waiting for the processor to connect, which could take up to 35 seconds.
Red Light
– The Bluetooth receiver has power.
Green Light
– When the proper active connection is
selected in the Hay App menu, the green light will indicate connection with the iPad.
Troubleshooting
PROBLEM
POSSIBLE CAUSE
SOLUTION
Moisture reading errors (high or low)
1. Wire disconnected or bad
connection w/ moisture disc-DCP
1. Reconnect wire.
2. Low power supply to DCP
2. Check voltage at box. Min of 12V
3. Wet hay over 60% moisture
4. Ground contact with one or both
moisture discs and BMP.
4. Reconnect.
5. Short in wire DCP-disc
5. Replace wire.
6. Check with hand tester
6. Contact Harvest Tec if no change
Moisture readings erratic.
1. Test bales with hand tester to
verify that cab monitor has variance
2. Check all wiring connections for
corrosion or poor contact.
2. Apply dielectric grease to all
connections.
3. Check power supply at tractor.
Voltage should be between 12-14V
3. Install voltage surge protection on
tractors alternator.
Terminal reads under or over power.
1. Verify with multi-meter actual
voltage. Voltage range should be
between 12-14 volts.
1. Clean connections and make sure
applicator is hooked to battery.
Bale rate displays zero.
1. Bale rate timer sensor error
2. Short in cable or sensor
1. Check, clean, tighten connections
2. Replace cable, Replace sensor.
Display will not power up.
1. Connection broke between the
display and the DCP.
2. Short in display cable.
1. Check, clean, tighten connections
2. Replace cable.
Bluetooth Receiver lights will not
illuminate
1. Bluetooth receiver not
connected
2. Harness disconnected, low pwr
1. Check connections and voltage.
Minimum 12.5V needed.
Blinking Lights
– System is waiting for the processor to connect, which could
take up to 35 seconds.
Red Light
– The Bluetooth receiver has power
Green Light
– When the proper active connection is selected in the Hay App
menu, the green light will indicate connection with the iPad.
