![background image](http://html1.mh-extra.com/html/harvest-tec/600rb/600rb_installation-manual_2103720007.webp)
7
Installation of Moisture Sensor Pads and Disks
(continued)
Installation of Bale Rate Timer Sensor
The bale rate timer sensor is used to determine when the baler door is open. With this information the system
is able to change the tons/hour automatically. Refer to Operation Manual for Operation Instructions, Automatic
Mode and also record information per bale.
Locate the sensor (006-7400) and the sensor bracket (001-4648RB). On the right side of the baler find a
location 1”– 6” (25mm-15cm) down from the hinge to mount the bracket. Check for clearance with hydraulic
cylinders before mounting the bracket. The bracket should be mounted to the front side of the hinge point, with
the sensor aligned over the back door.
Mark and drill two 1/4” holes and install the bracket using two 5/16” x 1-1/4” self-tapping bolts.
Install the sensor into the bracket and leave 1/4” (7mm) of clearance between the end of the sensor and the
door.
The harness will need to be routed towards the DCP. Secure with cable ties, be sure to avoid pinch points and
hydraulic lines. The harness extension (006-7400EXT) may need to be used.
001-4648RB
006-7400
Back Door
Front of baler
OSR (over-shot) rotor)
USR (under-shot rotor)
Hinge Point