E
[email protected] www.harvesthealthcare.co.uk
13
Cycle/Alternating Time
The cycle time can be selected by pressing the button on the control panel. The
cycle time options are 10, 15, 20 or 25 minutes. Consult a medical professional for
cycle times above ten minutes.
C
Pressure Range / Comfort Setting
The pump has a scale printed on the front panel in kilograms. Press the comfort
control button (-) or (+) until the nearest desired weight setting is illuminated on the
display panel. When the mattress is in use the user can adjust the comfort setting
as required for the service user’s needs. A slight increase of the comfort setting
may be required if the service user needs more support when the bed is profiled.
When the bed platform is laid flat readjust the setting as required for the service
user.
D
Alarm Mute
The pump is fitted with an audible and visual alarm. Press the ‘Mute’ button to
reset the alarm. Initially the alarm will sound after 40 mins if the mattress has not
fully inflated while in the start-up mode. Once safely inflated the alarm will sound if
it detects a cycle fault or low pressure fault on the system.
E
Alternating Mode
When pump is switched on for the first time it will inflate all the cells.
The alternating mode LED will illuminate to indicate that the pump is in start-up mode.
Once all the cells have been inflated the alternating mode will activate. The cells in the
mattress will then inflate and deflated to prove pressure relief for the service user.
F
Static Mode
The ‘Static Mode’ can be operated by the user to inflate all the cells for patient care
and transfers. Press the ‘Static Mode’ button and the LED will illuminate orange. The
‘Static Mode’ will stop working after 20 mins and the pump reverts back to normal
alternating mode.
G
OVERVIEW
Bed Hooks (Back of Pump)
Attach the pump to the foot end of the bed. Adaptor brackets are available to fit
different sizes of beds. If the pump cannot be attached to the foot end of the bed it is
the user’s responsibility to ensure that the pump is placed in such a position that it will
not cause harm or injury to the service user.
The pump unit must be placed so
that it can be clearly seen and monitored at all times.
K
Maxi-Firm Mode
Press the ‘Maxi-Firm’ button to automatically inflate the mattress to its maximum
pressure. This will take approximately 20 mins. During normal pressure operations the
pump will monitor the pressures.
Switch off the Maxi-Firm after use.
H
Seat Inflate Mode
Press the ‘Seat Inflate’ button. The pump will increase the pressure by 5mmHg while
this mode is activated. This function helps give the user extra support when the bed is
profiled. No other settings need to be altered, either when in use or after deactivation.
I
Lock Button
The ‘Auto Lock Out’ will become active after 5 minutes, signified by the LED green
light next to the padlock symbol. This function prevents alteration of the pump
settings. Deactivate the auto-lock by pressing and holding the padlock button.
The pump will bleep once and the LED light will extinguish. Access to the different
functions will now be made available
J