HART HPMT01, Operator'S Manual

Page: 6 / 24

6 – English
INSTALLING/REMOVING BATTERY PACK
See Figure 2, page 9.

Turn the variable speed dial to the OFF position.

Insert the battery pack into the battery port as shown.

Make sure the latch on the battery pack snaps into place
and the battery pack is secured in the product before
beginning operation.

Depress the latch and pull to release and remove the
battery pack.
For complete charging instructions, see the operator’s
manuals for your battery pack and charger.
INSTALLING ACCESSORIES
See Figures 3 - 4, page 9.

Remove the battery pack.

Using the hex key provided, rotate the screw counter-
clockwise. Remove the screw and washer assembly and
set aside.

Place the desired accessory on the head so that the
openings on the accessory fit on the raised parts of
the head. Reinstall the screw and washer and tighten
securely.
NOTE:
An adaptor may be needed to properly fit some
accessories for your multitool. If this applies to your
multitool, call 1-800-776-5191
.
A storage area for the
adaptor is located in the battery foot.
NOTE: Always follow the instructions for the accessory,in
addition to all instructions for this product.
OPERATION
WARNING:
Do not wear loose clothing or jewelry when operating
this tool. They could get caught in moving parts causing
serious injury. Keep head away from tool and work area.
Hair could be drawn into tool causing serious injury.
WARNING:
Unsecured work could be thrown towards the operator,
causing injury.
WARNING:
Keep hands away from blades. Do not reach underneath
work or around or over the blade while blade is moving.
Do not attempt to remove cut material when blade is
moving.
CUTTING
See Figure 5, page 9.
 Mark the line of cut clearly.

Hold the tool firmly in front of and clearly away from you.
Make sure blade is clear of any foreign material.


Depress the switch trigger to start the cutting action. Allow
the blade to come to full speed, then move the blade into
the work.

To cut, keep the teeth of the blade in the work surface and
move the back of the tool slowly in a constant sideways
motion.
NOTE:
If the line and writing on the blade looks blurry
when in use, you are using the correct amount of pressure.
If they become clear, you are using too much force.
Accessory Type Uses
Segment saw
blade
Flush cutting in wood and drywall
Wood blade Straight cutting in wood, metal, and plastic
Detail sanding
backing pad
Sanding in corners and other hard-to-reach areas
Sanding sheets
Sanding sheets in 60 grit (1), 80 grit (3), and 120 grit (1) are provided for sanding
in different applications