Uncontrolled when printed
–
Version 2
Step By Step Guide
–
Full Installation
The 3.5” alloy centre pole should finish flush with the front and rear
of the sheet, with the 4” inserts being additional to the length of the
centre pole at each side.
First you should measure the roll over sheet in length.
ENSURE TO PLACE THE SHEET ON A CLEAN SMOOTH SURFACE OR
PROTECTIVE SHEET.
Place the front and rear domes on the vehicle body (flush to both front
and back) to correspond with the roll over sheet length. The sheet
should start at 1.5”
from the front of the front domes to finish at 1.5
”
from the rear of the rear domes.
Fix fo
ur, 2”x2” dome brackets to the body and ensure that they line up
with the domes. Tek bolt the front brackets into place and weld the
rear brackets into place.
Fit the domes to the brackets. Tek bolt the front dome to the outside
edge of the front bulkhead. Ensure the bolts are evenly spaced at
around 8”.
